How to Replace a Nissan Juke Spare Key
Nissan Juke is a fun and stylish hatchback with an unusual engine setup. It's a bit noisy, but it's still enjoyable to drive.
The key fob battery in your Nissan Juke should be replaced every two years or every two years, or when it's low. You can do it yourself, however you'll need a few tools.
Dead Coin Battery
If the key fob on your Nissan Juke has stopped working, you should check the battery of your coin. It may be dead and require to be replaced, which is a simple fix that takes just some minutes. You can do this by flipping the fob upside down and accessing the tiny latch and release on the back. Replace the old battery and ensure it's on the bottom of the fob. Place the two halves of the fob carefully.
The fob will need to cleaned if it was exposed to water prior to being able to insert the new battery. It is possible to clean the fob using isopropyl or electronic cleaner and a towel. Then let it dry completely prior to installing the battery.
To start the car the key fob has to also be connected to the car. This can be done using the instructions in the owner's manual, or using an OBDII scan. The most likely reason for why the key fob was not working is because it wasn't connected to the car. emergency locksmith could also be that the fob has defective chip, however this is extremely rare. A new receiver module might be needed in this case. If this is the situation, it's best to be replaced by a certified technician.
Water Damage
The key fob is battery-powered, and the batteries must be replaced every two years or so, or at the first sign of your car not responding when you press the "start" button. The rubber seals on keys keep out water, but submerging the key fob in the pool or ocean can damage the electronic chip. If this is the situation, you will have to purchase a new key from Nissan or an automotive locksmith.
It's possible that the computer has lost connection with the key fob and this could be due to a number of factors. It can be fixed by restarting the car. If the "Key ID error" message is still visible it is necessary to contact Nissan for assistance.
Three of the most common causes are a dead battery for the key fob as well as a key not programmed, and an unrepaired key fob that is damaged. The first two are relatively simple to fix, while the third is harder to diagnose and repair on the spot, however it can be fixed with a bit of patience. WhoCanFixMyCar allows you to compare Nissan Key Replacement prices in your area and then book your repair. You can read customer reviews about local Nissan dealerships, Nissan mechanics, and garages in a matter of seconds.
Faulty Chip
The key fob inside your Nissan Juke has a special chip that sends an electronic signal to the car when you turn it. If the chip is not functioning properly, it can cause the key to stop working. In this instance you'll have to solve the issue by replacing the key. Your Nissan Juke key could be defective for a variety of reasons, including water damage or the battery of your coin is dead.
If your key fob stops working after a wash or bath, you need to check the chip for water damage. Make sure the metal retainers are in good shape and that the chip is not exposed to water. If you notice any signs of water damage, try taking off the battery and cleaning the electronic component using isopropyl alcohol or electronic cleaner.
If the chip is damaged If it is damaged, you should visit your local locksmith or dealer. They will need the year model, make, and year of your vehicle to find the replacement. You'll also need to record the VIN (Vehicle Identification Number) to ensure that the dealer or locksmith is aware of the exact key you own. This will enable them to locate the correct key code and confirm that they cut the correct one.
Faulty Receiver Module
The fob's key sends a radio signal to your vehicle to perform various functions. The key fob is able to unlock your trunk as you rush to get groceries or even start your car by pressing an icon on the fob. It can also open your windows and turn on the horn when you accidentally lock the keys in your car.
If the key fob isn't able to function, it could be due to a malfunction in the receiver module. The receiver modules are tuned to receive specific frequencies that correspond with the signals transmitted by the Nissan key fob. If your car is equipped with a faulty receiver module is damaged, it will cease to respond to any signal received from the key fob.
Regardless of how your Nissan key fob ends up getting damaged, it's always beneficial to have a spare key in event that the key is damaged or lost. A locksmith or dealer can program a spare key to work with your Nissan. This will help you avoid the hassles of losing your keys or locking them in your car.
If your Nissan Juke key fob has been exposed clean rain or tap water, the problem could be solved by cleaning it with isopropyl alcohol or electronic cleaner. If the chip has fried, you'll need to purchase the new keyfob, which can be programmed to your car by a dealer or locksmith.